If you’re looking 👀 to get started with Ultimaker and Cura software 💽, it’s important to follow these steps to ensure a 👨🦲 smooth installation process.
First, head to the Ultimaker website 🌐 and navigate to the Cura software section.
From there, download the 👾 Linux *.AppImage* file and save it to a preferred location.
Once you’ve done that, open the 📟 terminal and type *su* , then enter your password to gain admin access.
The next step is to install necessary packages using *sudo apt-get install fuse libfuse2*
Finally, make the downloaded Cura *.AppImage* file executable by right-clicking, selecting *Properties* , and enabling *Allow executing file as a program* .
Then, run the file and proceed with Cura installation and setup . These 📶 steps will help you get started with Ultimaker and Cura software 👨💻 quickly and easily.
*Articles*
———————–
–
–
– (Linux Commands)
[ad_2]
source
-
-
-
-
