How to Fix “Preparing Automatic Repair” Loop Error in Windows
Stuck in the frustrating “Preparing Automatic Repair” loop error on your Windows computer? Don’t worry, we’ve got the solution for you!
If you’re encountering this error message and your computer keeps restarting in a loop, here’s how you can fix it:
Restart your computer. Sometimes, a simple restart can resolve the issue and allow your PC to start normally.
Boot into Safe Mode. By accessing Safe Mode, you can troubleshoot and fix any potential software conflicts that may be causing the automatic repair loop. Press the F8 key during startup to enter Safe Mode.
Disable automatic startup repair. In Safe Mode, open the Command Prompt and enter the following command:
bcdedit /set {default} recoveryenabled No
This will disable the automatic startup repair feature.
Run system file checker. Use the Command Prompt to run the System File Checker tool, which can scan and repair corrupted system files. Enter the command
sfc /scannow
and wait for the process to complete.
Check for disk errors. Use the Command Prompt or a disk utility tool to scan and repair any potential errors on your hard drive.
Perform a system restore. If you recently installed new software or made changes to your system settings, a system restore can revert your PC back to a previous working state.
Reinstall Windows. If all else fails, reinstalling Windows can often resolve persistent issues. Make sure to back up your important files before proceeding with a fresh installation.
By following these steps, you can fix the “Preparing Automatic Repair” loop error and get your computer back to normal operation.
It’s important to note that this error can occur due to various reasons, including software conflicts, corrupted system files, or hardware issues. Troubleshooting steps may vary depending on your specific situation.
If this video has helped you out, please like the video and subscribe to our channel.
[ad_2]
source
