In this video we’re doing a basic standing seam metal roof, I hope y’all can learn something, and just be aware this might not be the exact type of trim and panels that you have access to in your area, but some of the basic principals could still apply. Also normally you would probably have an “A” Frame roof your working on, not a Lean-to like this one, in that case line up your Rake, (Gable, or Corner) trims up at the peak, and make all the points meet. On another note, Some metal roofing shops can make custom trim so take advantage of that,
Here are some of the tools we like to use, these can be found on amazon via the following links;
Left off-set snips:
Right off-set snips:
Edge roller:
The caulk we Love to use (super strong!!)
18” hand break:
You can also get this in a 24” length for Hemming the bottoms of valley angles on standing seam.
Our favorite gloves:
Our favorite roofing Shoes:
(AKA) Hiking Boots)
Power Metal Shear:
Impact driver:
Hand Break 6”:
Hand Notcher to notch the bottom edges of your standing seam panel for Hemming the bottoms if they don’t come pre-notched from the manufacturer:
Rubber Mallet:
I am an Amazon associate, and may earn a commission if you purchase any of the products using the links I have listed in the description.
[ad_2]
source
Curious where that second floor door leads to, or maybe it's being removed?
What gauge is this? Looks thin
Done shingles before but this is a first metal roof for me…. your video has been extremely helpful. Straight forward instruction.
Thank You
That tyoe of metal needs to be added some extra attention when fastening the clips otherwise the exposed marks will neglect the warranty from both material and labor. Inspectors pay much attention to those "minor" details.
Its like watching HGTV. You dont show any of the actual work, just the before & after.
Would have been nice to actually see the snapping together and fastening of the panels instead of time lapsing it from twenty feet away.
Great video. Why do you bend the sides and fold the edges?
Underlayment should probably be beneath the drip edge then seam tape where the underlayment and drip edge meet
How is the last panel attached to the roof?
why no underlayment on 2*6? are you in Arizona? correction, why no underlayment under trims? they would still have condensations, unless its a very dry state.
Any videos on how to install metal panels with 2inch foam in between sheets …. They're 4×8 with ridges about 10inches apart…. First time doing this type of metal roof I'm just trying to see what I can put on the top, side, and bottom edges…. Boss bought these looks like they were sawed off an older roof so the foam in between sheets have no slope …. Any advice or ideas would be appreciated thank you 🤘🏼
What is with the second story door leading out to the shed roof top?
What kind of siding is on this house?
Looking at the background….is this in Maine? Or, some other part of New England?
I like the video you guys did an excellent job of showing and explaining was a great help
Hey quick question what’s the rake trim name
Nice job. Great info. Thanks!
good work
Thanks guys, It's nice to find DIY videos made as well as yours. I can't think of anything that would make it better. Thanks again.
very professional. Nice work.
where do i buy the bending machine
I liked your presentation. I just need more tools 🥰🥰
Nice work guys, can you make a door to close the end on the overlapping panel at the drip edge